EPS line cutting machine parameters and debugging |
[
Date of publication:2014/6/26 ] |
Machine parameters a, EPS cutting machine:
If the cutting graph is greater than 1000mm, such as the radius of R is greater than 800mm, the above parameters range of machine in general use, you need to change the EPS line cutting machine parameter ratio.
1 EPS CNC cutting machine is a kind of precision equipment, so the cutting machine operators must be fixed, set machine, posts, must be done by a professional cutting machine.
2 to high precision, high quality EPS moulding products, must have the cutting high precision EPS.
So the EPS cutting machine operators must be strictly in accordance with the following procedure.
EPS line (if it is Windows98 system only need to XY-AXISUNIT [10] to [1], without the need to restart.) In the drawing page drawing will be reduced 10 times the original size (i.e., the input data and graph data than 1:10) such as workpiece size is 800mm, when the EPS line drawing component is 80mm, if the parameters change back to the original will just follow the steps above, the "1" back "10."
Professional CNC cutting machine, horizontal hanging wire, hot melt cutting. With low cost, one can cut 4.32 cubic materials;?
NC 2 professional coating machine, using non chain transmission, ensure produce width of 900mm lines smooth delivery, precision positioning and rapid replacement of die chamber device, speed controllable 0-18 meters per minute.
|
|